Here is my final logo, as to those who commented, I greatly appreciate your feedback and I am glad to hear your opinions. I have followed some of the suggestions as I was thinking the same. To start this design, I simply placed a B in the middle and added bran photo under it. Then I began to work on the wings. Originally, I wanted the wings to be more bird-like. As I was working on them, I came to find that this wasn’t going to work out because the arc tool was not acting as I wanted it to. For some reason it would not let me color the inside of it which I thought was strange but I still made the wings work. I actually only created one wing, then copied and pasted it to create the wings on one side of the B. I then simply grouped them, copied, and pasted them. Of course then all I did was just mirror them and place them so that they were the exact same on each side. I then added a black diamond, a symbol of my fraternity, Phi Gamma Delta, and I was done. To revise the logo and get it ready for finalization, I figured that some aspect of photography should be in this logo so what better than a camera? I replaced the black diamond that was on the B with a small camera. In addition to this change, I also took of Bran Photo from the bottom of the B. Then, I simply made it say “photo.” I believe this creates a cleaner logo that is easier to read and understand. Again, thank you for those who commented as this was a suggestion that confirmed my thoughts as well, and I believe it worked out very well with the font that I ended up picking. Also, I played around with the B a little, and after trying a few different color schemes with the wings, I decided that it would look better if I left the B white. However, I did change it so that the wings went right up to the black stroke of the B, instead of there being a small gap in between the two. After this, I was satisfied with the logo, I scaled it so that it would fit the whole artboard, and here it is now.
WELCOME 